Dimplex CAB15AR Manual do Utilizador descarregar pdf (Página 6)

Remote (BMS / BEMS) Operation

Connection to Building Energy Management Control Systems

(BEMS) is possible so that remote control of the air curtain can

be carried out in conjunction with other equipment.

Modular Connection

Refer to instructions provided with the modular linking kit.

Recessed Installation

Refer to instructions provided with the recess installation kit.

De-rating the unit to operate at 1/2 heat setting:

De-rating the unit to operate at 1/2 heat is done via the remote

switch unit, once the cover/facia plate is removed from the

backbox, access can be gained to the connection block inside -

for details refer to Switch Panel Instructions.

To de-rate the unit to half heat setting, insert the wire for H2 from

in with the wire for H1. By doing this the switch function will allow

half heat setting in either half or full heat mode, provided the

correct number of cores are fed to the switch unit this still allows

possible reconnection to full heat at a later stage.

At half heat setting the units detailed within the table below will

give the loadings stated.

H2 connected to H1

Model Heat Output Loading per phase

CAB10E 4.5kW 7.0A

CAB15E 6.75kW 10.0A

DAB10E 6.0kW 9.0A

DAB15E 9.0kW 13.5A

The CAB10E and CAB15E are primarily designed for 400V~ 3P&N

50Hz operation, however in the instance where it is not possible

to utilise a 3-phase supply, the CAB10E & CAB15E units can be

derated for operation via a 230V~ 1P&N 50Hz supply (please

note that in 230V~ 1P&N, a maximum loading of 1/2 heat only

will be applicable). To do this a kit will be needed please contact

Dimplex for further information.

1 2 3 4 5 6 7 8

Sem comentários

Dimplex CAB15AR Manual do Utilizador Página 6