Dimplex ELECTRALOG CS2307 Guia do Utilizador descarregar pdf (Página 6)

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn the heater off and it will not come

back on without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF

and waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call customer service at

1-800-668-6663.

MAINTENANCE

WARNING

Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire,

electric shock or damage to persons.

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for the light bulb to cool off before touching, to avoid accidental

burning of the skin.

The light bulb needs to be replaced when you notice a dark section of the flame or when the

clarity and detail of the log exterior disappears. There is one bulb located at the back of the

unit behind the access panel.

LOWER LIGHT BULB REQUIREMENTS

Quantity of 1 clear chandelier or candelabra bulb with an E-12 (small) socket base, 60 watt

rating.

TO REPLACE THE LIGHT BULB (see FIGURE 2)

1. Remove the five screws from the access panel, located on the back of the unit, and

remove access panel.

2. Locate and examine the bulb to determine if replacement is required.

3. Unscrew the bulb counter clockwise.

4. Insert new bulb.

5. Secure access panel to unit.

1 2 3 4 5 6 7 8 9

Sem comentários

Dimplex ELECTRALOG CS2307 Guia do Utilizador Página 6