Dimplex DF2000 Manual de Serviço descarregar pdf (Página 10)

10 www.dimplex.com

13. Slide the icker rod out of the snap-in bushing and

remove.

14. Reassemble in the reverse order as above.

LED DRIVER BOARD REPLACEMENT

Tools Required: Phillips Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

NOTE: Steps 3-5 are only applicable for units with

logset assemblies.

3. Remove the two screws that secure the front glass

retaining bracket to the unit. (Figure 6)

4. Remove the front glass and set aside in a safe place.

5. Remove the retaining screw in the front middle of the

grate.

6. Remove the three screws along the back of the unit

and the two on either side along the bottom edge.

(Figure 7)

7. Lay the Compact Fireplace on its back.

8. Gently open the bottom panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 8)

9. Locate the LED driver board and disconnect the wiring

connections noting their original locations.

NOTE: A at head screwdriver can be used to gently

pry between the end of the connector and the switch to

release the wires.

10. Release the driver board from the top panel by using

needle nose pliers to depress the tab on the mounting

standoffs and gently lift the driver board off.

11. Properly orient and install the new LED driver board

and connect all of the wiring.

12. Reassemble in the reverse order as above.

LED LIGHT ASSEMBLY REPLACEMENT

Tools Required: Phillips Head Screwdriver

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights, heating elements and top

panel to cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Unplug the unit from power outlet.

2. Remove the rebox from the back of the mantel by

removing the retaining screws which secure the rebox

brackets to the mantel.

NOTE: Steps 3-5 are only applicable for units with

logset assemblies.

3. Remove the two screws that secure the front glass

retaining bracket to the unit. (Figure 6)

4. Remove the front glass and set aside in a safe place.

5. Remove the retaining screw in the front middle of the

grate.

6. Remove the three screws along the back of the unit

and the two on either side along the bottom edge.

(Figure 7)

7. Lay the Compact Fireplace on its back.

8. Gently open the bottom panel, laying it on the work sur-

face so that all of the components can easily be seen.

(Figure 8)

9. Locate the LED lights along the back. Each light is

secured with four screws and there is a light lter that is

sandwiched between the light assembly and the sheet

metal bracket.

NOTE: New light lters are not provided with replace-

Flicker Rod

Flicker Motor

Terminal Block

LED Driver

Board

Figure 8

Side Section

Front

Edge

Log

Ember

Bed

Back

Ledge

Rear

Tab

Figure 9

LED Lights

1 2 ... 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

Dimplex DF2000 Manual de Serviço Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Lareiras Dimplex DF2000