Dimplex DC12 Manual de Serviço descarregar pdf (Página 18)

PowerFlex 700L Technical Data

18 Publication 20L-TD001A

Frame 3A/3B Drive

Recommended Mounting Clearances

Be sure there is adequate clearance for air circulation around the drive enclosures. A 15 cm (6-in.) minimum clearance is

required wherever vents are located in the cabinet.

Determining Wire Routing for Control, Ground, Drive Input, and Motor Output

All wiring should be installed in conformance with the applicable local, national, and international codes (e.g., NEC/

CEC). Signal wiring, control wiring, and power wiring must be routed in separate conduits to prevent interference with

drive operation. Use grommets, when hubs are not provided, to guard against wire chafing.

Do not route signal and control wiring with power wiring in the same conduit. This can cause interference with drive

operation. Failure to observe this precaution could result in damage to, or destruction of, the equipment.

Do not route more than three sets of motor leads through a single conduit. This will minimize cross-talk that could reduce

the effectiveness of noise reduction methods. If more than three drive/motor connections per conduit are required,

shielded cable must be used. If possible, each conduit should contain only one set of motor leads.

Frame 3A Power Terminal Locations

Coolant Outlet

Coolant Inlet

➊

➌

➍

➋

24 VDC

TB5

DC POSITIVE

DC NEGATIVE

1 120 VAC

2 PRECHARGE COIL

3 120 VAC NEUTRAL

7 INDUCTOR OVERTEMP

WIRE RANGE:

24-10 AWG

(0.2-4 MM)

5 PR HARGE FEEDBACK

GATE ENABLE

STRIP LENGTH:

0.31 IN (8 MM)

TORQUE:

8 IN-LB

(0.9 N-M)

PORT

MOD

NET A

NET B

POWER

STS

(Drive shown with

doors removed)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Comentários a estes Manuais

Sem comentários

Dimplex DC12 Manual de Serviço Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Dimplex DC12