Dimplex DC12 Manual de Serviço descarregar pdf (Página 37)

PowerFlex 700L Technical Data

Publication 20L-TD001A 37

Standard Drive Specifications

The following specifications, unless otherwise noted, pertain to PowerFlex 700L drives equipped with 700 Vector Control

or 700S Phase II Control.

Category

Specification

Frame 2 Frame 3A/3B

Protection 400V 480V 400V 480V 600V 690V

AC Input Overvoltage Trip: 528V AC 528V AC 528V AC 528V AC 760V AC 760V AC

AC Input Undervoltage Trip: 340V AC 340V AC 340V AC 340V AC 340V AC 340V AC

Bus Overvoltage Trip: 815V DC 815V DC 815V DC 815V DC 1168V DC 1168V DC

Bus Undervoltage Shutoff/Fault: 300V DC 300V DC 300V DC 300V DC 300V DC 300V DC

Nominal Bus Voltage: 600V DC 700V DC 600V DC 700V DC 900V DC 1000V DC

Heat Sink Thermistor: Monitored by microprocessor overtemp trip

Drive Overcurrent Trip

Software Overcurrent Trip:

Hardware Overcurrent Trip:

200% of rated current (typical)

220-300% of rated current (dependent on drive rating)

Line Transients: Up to 6000 volts peak per IEEE C62.41-1991

Control Logic Noise Immunity: Showering arc transients up to 1500V peak

Logic Control Ride-Thru

Vector Control: 0.5 seconds minimum, 2 seconds typical

700S Phase II Control: 0.25 seconds, drive not running

Ground Fault Trip: Phase-to-ground on drive output

Short Circuit Trip: Phase-to-phase on drive output

Environment Altitude: 1000 m (3280 ft.) at rated current. See Derating Guidelines

on page 40 for operation above 1000 m (3280 ft.).

Maximum Surrounding Air

Temperature w/o Derating:

IP20, NEMA/UL Type 1: 0 to 50°C (32 to 122°F) 0 to 40°C (32 to 104°F)

Storage Temperature

(all constructions): –40 to 85°C (–40 to 185°F)

Atmosphere: Important: Drive must

not be installed in an area where the ambient atmosphere contains volatile or corrosive gas,

vapors or dust. If the drive is not going to be installed for a period of time, it must be stored in an area where it will not

be exposed to a corrosive atmosphere.

Relative Humidity: 5 to 95% non-condensing

Shock: 10G peak for 11 milliseconds duration (± 1.0 ms)

Vibration: 0.152 mm (0.006 in.) displacement, 1G peak, 5.5 Hz

N223

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Sem comentários

Dimplex DC12 Manual de Serviço Página 37